Drill the hole according to the installation table (M8: Ø10 mm to M24: Ø26 mm), blow it out and clean it with a brush until it is free of dust and grease. Squeeze out the first approximately 3 cm of resin until the colour is uniform, fill the drill hole from the bottom up to about two-thirds full, and screw the threaded end in with a gentle twisting motion. After the curing time, apply the tightening torque specified in the table (M8: 10 Nm to M24: 200 Nm); the anchorage is suitable for long-term use up to +50 °C (short-term up to +80 °C).