Hoe breng je een chemisch anker correct aan?

Drill the hole according to the installation table (from Ø10 mm for M8 to Ø26 mm for M24), blow it out and clean it with a cleaning brush until it is completely free of dust and grease. Insert the 300 ml cartridge into the dispensing gun, fit the static mixing nozzle and squeeze out the first approximately 3 cm of resin until the colour is uniform. Fill the drill hole from the bottom up to approximately two-thirds full, screw the threaded rod in to the required embedment depth and do not apply load until after the specified curing time; in hollow substrates, use a sieve sleeve.